Total Recall VR Accessories - Daytronik Solutions

Daytronik Header
Daytronik Logo
Go to content

Total Recall VR Accessories

Products > Digital Voice Loggers > Total Recall VR Digital Voice Logging
Total Recall VR Audio Mixer
Total Recall VR Audio Mixer brochureTotal Recall VR Audio Mixer is a low noise 2-channel mixer that can combine two audio sources into one. You can use Total Recall VR Audio Mixer to:
  • Combine (mix) a stereo audio signals into a mono signal
  • Combine (mix) any two line level audio signals into a single line level signal
  • Combine (mix) the transmit (Tx) and receive (Rx) audio signal of a 2-way radio, repeater or base station

Specifications:
  • 3.5mm TS and RJ12 connector for each input
  • Signal level control (gain) for each input
  • Redundant line-level output
  • 3.5mm TS and RJ12 connector for each output
  • 9-15VDC power source centre negative
  • Maximum output signal level +16dBu (with 15VDC power supply)
  • Minimum input signal level: -30dBu
  • Input impedance: 100Kohm
  • Frequency response: 20Hz-20KHz
  • Total harmonic distortion: < .005%

The Total Recall VR Audio Mixer requires a 9VDC-12VDC power pack to power the mixer. This power pack is NOT supplied with the unit. Use an optional rack mount shelf to install up to 4 Mixers (1RU) or up to 16 Mixers (3RU) into an equipment rack.
Total Recall VR Logger Patch
Total Recall VR Logger Patch brochureThe Total Recall VR Logger Patch enables recording from digital telephone handsets where there is no-side tone or the level of the microphone is too low to trigger recording.

The Logger Patch is simply connected to the telephone handset curly cord and  then wired to an analogue port on a Total Recall VR voice logging recorder.

Some phone handsets have different microphone and earpiece outputs to the  RJ11 (4P4C) plug. Normally the center two wires on the handset jack are the  earpiece circuit and the outer two wires are the microphone. If your telephone  does not use standard connections, there is a splitter included in the pack to  reverse the input connections to the Logger Patch.

The Logger Patch requires a 12VDC power pack to power the amplifier which  will give up to 30dB gain on the microphone and 10dB gain on the earpiece. This  power pack is NOT supplied with the Logger Patch.

Copyright Daytronik Solutions 2018
Back to content